tigercoyote
3191 צפיות

Installation 2018 800XR

Flexes 180 degrees. Start with picture 1
35 תמונות — לפני 5 שנתיים
33-Push-Center-Till-Just-Clicks--Repeat-Process-Other-Side.jpg
33 Push Center Till Just Clicks & Repeat Process Other Side
32-Pull-Rivet-Center-to-Install-Position.jpg
32 Pull Rivet Center to Install Position
31-Reverse-Fairing-Removal-Steps-to-Finish.jpg
31 Reverse Fairing Removal Steps to Finish
30-Tab-Covers-Bolt-Hole.jpg
30 Tab Covers Bolt Hole
29-Orientate-Same-as-Stock--Tighten.jpg
29 Orientate Same as Stock & Tighten
28-Install-With-Flange-Nut-Provided.jpg
28 Install With Flange Nut Provided
27-Stagger-Solder--Insulate-Tuff-Lights-to-Stock-Blk-Blk-Brn-Wht.jpg
27 Stagger Solder & Insulate Tuff Lights to Stock Blk Blk Brn Wht
25-Same-Fit-As-Mounting-Tab.jpg
25 Same Fit As Mounting Tab
26-Slip-On-Shrink-Tube-Before-Soldering.jpg
26 Slip On Shrink Tube Before Soldering
24-Enlarge-Fairing-Signal-Wire-Hole-Only.jpg
24 Enlarge Fairing Signal Wire Hole Only
23-Tab-Almost-Threads-On-Not-Loose.jpg
23 Tab Almost Threads On Not Loose
22-Enlarge-Tab-Hole-For-Tuff-Light-Stem.jpg
22 Enlarge Tab Hole For Tuff Light Stem
21-Tuff-Light-With-Mounting-Tab.jpg
21 Tuff Light With Mounting Tab..See "About" below for where I obtained tabs..
20-Remove-Terminals--Back-Wires-Out-of-Housing-Stem.jpg
20 Remove Terminals & Back Wires Out of Housing Stem
19-Disconnect-Terminals.jpg
19 Disconnect Terminals
18-Back-of-Reflector.jpg
18 Back of Reflector
17-Disassmble-Signal-Housing.jpg
17 Disassmble Signal Housing
16-Stock-Signal.jpg
16 Stock Signal
15-Removing-Stock-Signal.jpg
15 Removing Stock Signal
14-Remove-Stock-Signal.jpg
14 Remove Stock Signal
13-Note-Stock-Signal-Orientation.jpg
13 Note Stock Signal Orientation
12-Unhook-Signal-Wire-From-Holder.jpg
12 Unhook Signal Wire From Holder
11-Unplug-Turn-Signal.jpg
11 Unplug Turn Signal
7-Remove-Rear-Upper-Outside-Tank-Fairing-Bolt.jpg
7 Remove Rear Upper Outside Tank Fairing Bolt